Renfrewshire and Inverclyde · Block paved driveways

Block paving driveways in Port Glasgow

Our block paving driveways service covers Port Glasgow and nearby Greenock, from first measurements to the final sweep of kiln-dried sand. You get a written, itemised quote before anything is booked.

  • Postcodes PA14, PA13
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Planning a block paved driveway in Port Glasgow

Around Port Glasgow, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.

Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a block paved driveway cost in Port Glasgow?

Guide price in Port Glasgow£85–£140 per m²Including VAT at 20%

Expect block paved driveways in Port Glasgow to come in at around £85–£140 per m², including VAT at 20%. As an example, a 50 m² double drive usually comes to between £4,250 and £7,000.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our block paved driveways service

A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.

  • Sharp-sand laying course screeded to falls
  • Crushed-stone sub-base laid in layers and compacted
  • Survey, measurements and a written, itemised quote
  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Cuts at edges, around covers and against the house

What we check on a Port Glasgow survey

  • Block range, thickness, colour and pattern to suit the house
  • Whether front-garden planning rules apply
  • Where an electric vehicle charger cable might run
  • Ground conditions under the old surface and how deep the sub-base must be
  • Access for a mini-digger, skip or grab lorry

Do you need permission in Port Glasgow?

Port Glasgow is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Send the basics

    Postcode, what you need and a rough size. Photos help.

  2. Survey

    We measure, check levels, ground and drainage, and talk through blocks and patterns.

  3. Written quote

    An itemised quote with the specification, the price and the start date.

  4. The work

    Our paving team builds it to the agreed specification and leaves the site swept.

Why choose Block Paving Contractors

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Block paved driveways in Port Glasgow: questions

Can you match the blocks to my house in Port Glasgow?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

How much does a block paved driveway cost in Port Glasgow?

Our guide for Port Glasgow is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.

Do you cover Greenock, Gourock and Erskine?

Yes. We cover Port Glasgow and the places around it, including Greenock, Gourock and Erskine, and the rest of Renfrewshire and Inverclyde.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Block paved driveways near Port Glasgow

Nearby towns we cover for block paved driveways, and block paved driveways across Renfrewshire and Inverclyde:

Other block paving services in Port Glasgow

Or see all block paving services in Port Glasgow.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote