What to know before a replacement block drive in Blackburn
Blackburn has everything from short terrace frontages to wide drives on newer estates, so the survey sets the layout and the dig.
The North West is one of the wetter parts of England, so falls, channel drains and permeable options matter more than usual.
How much does a replacement block drive cost in Blackburn?
For Blackburn, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Drainage added where the old drive sent water to the house or road
- Assessment of the old base: keep, top up or replace
- Break-out of the old surface with waste removal and skip or grab lorry
What the survey covers
- The kerb: is it already dropped, and is it wide enough?
- Whether front-garden planning rules apply
- Where rain will go: falls, lawn, border, channel or soakaway
- Where an electric vehicle charger cable might run
- Steps, thresholds and door heights
Planning and kerb rules in Blackburn
Blackburn is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Why choose Block Paving Contractors
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Replace an old drive in Blackburn: questions
Do I need planning permission for a replacement block drive in Blackburn?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Do you cover Darwen, Accrington and Chorley?
Yes. We cover Blackburn and the places around it, including Darwen, Accrington and Chorley, and the rest of Lancashire.
Is the survey in Blackburn free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Replace an old drive near Blackburn
Nearby towns we cover for replace an old drive, and replace an old drive across Lancashire:
- Replace an old drive in Darwen
- Replace an old drive in Accrington
- Replace an old drive in Chorley
- Replace an old drive in Rawtenstall
- Replace an old drive in Preston
- Replace an old drive in Leyland
