Somerset · Drive extensions

Block paved driveway extensions in Frome

Block paved driveway extensions in Frome: built on a properly dug and compacted base, edged in concrete and laid to falls that take water away from the house.

  • Postcodes BA11, BA3
  • £90–£150 per m² inc VAT
  • Free survey for new paving
Widened block paved driveway with a new matching section joined to the original drive

Block paved driveway extensions in Frome: the local picture

Frome is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.

Sloping plots are common in the South West, which affects edging, steps and where the water runs.

How much does a driveway extension cost in Frome?

Guide price in Frome£90–£150 per m²Including VAT at 20%

In the South West, a driveway extension usually costs £90–£150 per m² including VAT. For a 15 m² extension, that is roughly £1,550–£2,600. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.

ItemGuide price inc VAT
Driveway extension in block paving£90–£150 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the South West, checked 9 November 2026. See all prices or use the guide price tool.

What does a driveway extension involve?

A driveway extension adds paving to an existing drive, usually to fit a second car by taking in part of the front lawn, or to lengthen a drive towards the house or garage. The new section is built on its own sub-base and tied into the old paving so the two act as one surface.

  • Matching options: same range, re-mixing old and new, or a planned contrast
  • Old edge restraint taken out and the new paving toothed into the old pattern
  • Joint sand, compaction and a clean-down of the old section
  • Dig-out and sub-base for the new area
  • Check of the existing drive: block range, thickness, levels and condition

What the survey covers

  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Where rain will go: falls, lawn, border, channel or soakaway
  • Access for a mini-digger, skip or grab lorry
  • Block range, thickness, colour and pattern to suit the house
  • Ground conditions under the old surface and how deep the sub-base must be

Rules for front drives in Frome

Frome is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

Why choose Block Paving Contractors

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Drive extensions in Frome: questions

Can you match the blocks to my house in Frome?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

How much does a driveway extension cost in Frome?

Our guide for Frome is £90–£150 per m² including VAT, so a 15 m² extension is usually about £1,550–£2,600. Your fixed price follows the survey.

Do you cover Bath, Nailsea and Yeovil?

Yes. We cover Frome and the places around it, including Bath, Nailsea and Yeovil, and the rest of Somerset.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Drive extensions near Frome

Nearby towns we cover for drive extensions, and drive extensions across Somerset:

Other block paving services in Frome

Or see all block paving services in Frome.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote