Renfrewshire and Inverclyde · Replace an old drive

Replacing tarmac or concrete with block paving in Clarkston

If you are in Clarkston (G76) and want a replacement block drive, we will come out, measure up and give you a fixed written price once the specification is agreed.

  • Postcodes G76
  • £95–£180 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

What to know before a replacement block drive in Clarkston

Clarkston is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.

Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a replacement block drive cost in Clarkston?

Guide price in Clarkston£95–£180 per m²Including VAT at 20%

Expect replacement block drives in Clarkston to come in at around £95–£180 per m², including VAT at 20%. As an example, a 45 m² replacement drive usually comes to between £4,300 and £8,100.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£95–£180 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • New edging, sub-base where needed, and the block drive
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Drainage added where the old drive sent water to the house or road
  • Assessment of the old base: keep, top up or replace
  • Levels set below the damp-proof course with falls away from the house

What we check on a Clarkston survey

  • Where an electric vehicle charger cable might run
  • Whether front-garden planning rules apply
  • Access for a mini-digger, skip or grab lorry
  • Existing manhole and inspection covers, and whether to recess them
  • Ground conditions under the old surface and how deep the sub-base must be

Planning and kerb rules in Clarkston

Clarkston is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

Why choose Block Paving Contractors

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Replace an old drive in Clarkston: questions

Can you match the blocks to my house in Clarkston?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

How much does a replacement block drive cost in Clarkston?

Our guide for Clarkston is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.

Is the survey in Clarkston free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Do you cover Giffnock, Newton Mearns and Barrhead?

Yes. We cover Clarkston and the places around it, including Giffnock, Newton Mearns and Barrhead, and the rest of Renfrewshire and Inverclyde.

Replace an old drive near Clarkston

Nearby towns we cover for replace an old drive, and replace an old drive across Renfrewshire and Inverclyde:

Other block paving services in Clarkston

Or see all block paving services in Clarkston.

Next step

Get a guide price in two minutes

Get a guide price in a couple of minutes with our quote tool, or book a survey in Clarkston.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote