Replacing tarmac or concrete with block paving in Crieff: the local picture
Crieff is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Crieff?
For Crieff, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Drainage added where the old drive sent water to the house or road
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
What we check on a Crieff survey
- Where rain will go: falls, lawn, border, channel or soakaway
- Trees and roots near the drive
- Existing manhole and inspection covers, and whether to recess them
- The kerb: is it already dropped, and is it wide enough?
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
Planning and kerb rules in Crieff
Crieff is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
One point of contact
You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Replace an old drive in Crieff: questions
Do I need planning permission for a replacement block drive in Crieff?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How much does a replacement block drive cost in Crieff?
Our guide for Crieff is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do you cover Auchterarder, Perth and Scone?
Yes. We cover Crieff and the places around it, including Auchterarder, Perth and Scone, and the rest of Perth and Kinross.
Replace an old drive near Crieff
Nearby towns we cover for replace an old drive, and replace an old drive across Perth and Kinross:
- Replace an old drive in Auchterarder
- Replace an old drive in Perth
- Replace an old drive in Scone
- Replace an old drive in Blairgowrie
