Replacing tarmac or concrete with block paving in Golborne: the local picture
In and around Golborne, village-style frontages sit alongside newer cul-de-sacs, so the right block often depends on the age of the house.
Terraced streets across the North West often have very short frontages, so we check parking depth before quoting a conversion.
How much does a replacement block drive cost in Golborne?
For Golborne, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Assessment of the old base: keep, top up or replace
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
- Drainage added where the old drive sent water to the house or road
- Levels set below the damp-proof course with falls away from the house
What the survey covers
- The kerb: is it already dropped, and is it wide enough?
- Edges against lawns, beds, walls and neighbours
- Ground conditions under the old surface and how deep the sub-base must be
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Access for a mini-digger, skip or grab lorry
Do you need permission in Golborne?
Golborne is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Send the basics
Postcode, what you need and a rough size. Photos help.
Survey
We measure, check levels, ground and drainage, and talk through blocks and patterns.
Written quote
An itemised quote with the specification, the price and the start date.
The work
Our paving team builds it to the agreed specification and leaves the site swept.
What you can expect from us
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Replace an old drive in Golborne: questions
Do you cover St Helens, Prescot and Huyton?
Yes. We cover Golborne and the places around it, including St Helens, Prescot and Huyton, and the rest of Merseyside.
Do I need planning permission for a replacement block drive in Golborne?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
How much does a replacement block drive cost in Golborne?
Our guide for Golborne is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Replace an old drive near Golborne
Nearby towns we cover for replace an old drive, and replace an old drive across Merseyside:
- Replace an old drive in St Helens
- Replace an old drive in Prescot
- Replace an old drive in Huyton
- Replace an old drive in Kirkby
- Replace an old drive in Halewood
- Replace an old drive in Speke
