What to know before a replacement block drive in Kirkby
Kirkby is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
The North West is one of the wetter parts of England, so falls, channel drains and permeable options matter more than usual.
How much does a replacement block drive cost in Kirkby?
Most replacement block drive quotes in the North West fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Levels set below the damp-proof course with falls away from the house
What the survey covers
- Edges against lawns, beds, walls and neighbours
- Trees and roots near the drive
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Access for a mini-digger, skip or grab lorry
- Ground conditions under the old surface and how deep the sub-base must be
Do you need permission in Kirkby?
Kirkby is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
What you can expect from us
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Kirkby: questions
Do you cover Maghull, Prescot and Bootle?
Yes. We cover Kirkby and the places around it, including Maghull, Prescot and Bootle, and the rest of Merseyside.
Is the survey in Kirkby free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Do I need planning permission for a replacement block drive in Kirkby?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Replace an old drive near Kirkby
Nearby towns we cover for replace an old drive, and replace an old drive across Merseyside:
- Replace an old drive in Maghull
- Replace an old drive in Prescot
- Replace an old drive in Bootle
- Replace an old drive in Huyton
- Replace an old drive in Liverpool
- Replace an old drive in St Helens
