Replacing tarmac or concrete with block paving in Morecambe: the local picture
Morecambe is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
The North West is one of the wetter parts of England, so falls, channel drains and permeable options matter more than usual.
How much does a replacement block drive cost in Morecambe?
For Morecambe, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Drainage added where the old drive sent water to the house or road
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
- New edging, sub-base where needed, and the block drive
- Levels set below the damp-proof course with falls away from the house
Before we price your replacement block drive
- Ground conditions under the old surface and how deep the sub-base must be
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Existing manhole and inspection covers, and whether to recess them
- Steps, thresholds and door heights
- Where an electric vehicle charger cable might run
Rules for front drives in Morecambe
Morecambe is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Why choose Block Paving Contractors
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
One point of contact
You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.
Replace an old drive in Morecambe: questions
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
How much does a replacement block drive cost in Morecambe?
Our guide for Morecambe is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do you cover Lancaster, Fleetwood and Thornton-Cleveleys?
Yes. We cover Morecambe and the places around it, including Lancaster, Fleetwood and Thornton-Cleveleys, and the rest of Lancashire.
Do I need planning permission for a replacement block drive in Morecambe?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Replace an old drive near Morecambe
Nearby towns we cover for replace an old drive, and replace an old drive across Lancashire:
- Replace an old drive in Lancaster
- Replace an old drive in Fleetwood
- Replace an old drive in Thornton-Cleveleys
- Replace an old drive in Blackpool
- Replace an old drive in Preston
- Replace an old drive in Lytham St Annes
