Greater London · Replace an old drive

Replacing tarmac or concrete with block paving in Bexley

Our replacing tarmac or concrete with block paving service covers Bexley and nearby Welling, from first measurements to the final sweep of kiln-dried sand. You get a written, itemised quote before anything is booked.

  • Postcodes DA5, DA6, DA7
  • £115–£215 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Bexley

Bexley has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.

Many London streets have controlled parking and narrow frontages, so we measure the car space and the crossover before anything else.

How much does a replacement block drive cost in Bexley?

Guide price in Bexley£115–£215 per m²Including VAT at 20%

Guide price in Bexley: £115–£215 per m² including VAT, which puts a 45 m² replacement drive at about £5,150–£9,700. These are London guide figures; the survey confirms the real price before you commit.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£115–£215 per m²
Breaking out an old surface£12–£50 per m²
Edging or kerb, bedded and haunched£25–£60 per metre
Typical channel drain run£420–£1,200
Dropped kerb (vehicle crossover) construction£1,200–£3,600

Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • New edging, sub-base where needed, and the block drive
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Levels set below the damp-proof course with falls away from the house
  • Assessment of the old base: keep, top up or replace
  • Drainage added where the old drive sent water to the house or road

What the survey covers

  • Existing manhole and inspection covers, and whether to recess them
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Whether front-garden planning rules apply
  • Where an electric vehicle charger cable might run
  • Edges against lawns, beds, walls and neighbours

Rules for front drives in Bexley

Bexley is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

What you can expect from us

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Replace an old drive in Bexley: questions

How much does a replacement block drive cost in Bexley?

Our guide for Bexley is £115–£215 per m² including VAT, so a 45 m² replacement drive is usually about £5,150–£9,700. Your fixed price follows the survey.

Do you cover Welling, Eltham and Thamesmead?

Yes. We cover Bexley and the places around it, including Welling, Eltham and Thamesmead, and the rest of Greater London.

Is the survey in Bexley free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Do I need planning permission for a replacement block drive in Bexley?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Replace an old drive near Bexley

Nearby towns we cover for replace an old drive, and replace an old drive across Greater London:

Other block paving services in Bexley

Or see all block paving services in Bexley.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote