Planning a replacement block drive in Barrow-in-Furness
Barrow-in-Furness is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
Terraced streets across the North West often have very short frontages, so we check parking depth before quoting a conversion.
How much does a replacement block drive cost in Barrow-in-Furness?
Guide price in Barrow-in-Furness: £95–£180 per m² including VAT, which puts a 45 m² replacement drive at about £4,300–£8,100. These are North West guide figures; the survey confirms the real price before you commit.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
Before we price your replacement block drive
- Where an electric vehicle charger cable might run
- Where rain will go: falls, lawn, border, channel or soakaway
- Whether front-garden planning rules apply
- Edges against lawns, beds, walls and neighbours
- The kerb: is it already dropped, and is it wide enough?
Do you need permission in Barrow-in-Furness?
Barrow-in-Furness is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Replace an old drive in Barrow-in-Furness: questions
Is the survey in Barrow-in-Furness free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Do I need planning permission for a replacement block drive in Barrow-in-Furness?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Do you cover Kendal, Morecambe and Fleetwood?
Yes. We cover Barrow-in-Furness and the places around it, including Kendal, Morecambe and Fleetwood, and the rest of Cumbria.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Replace an old drive near Barrow-in-Furness
Nearby towns we cover for replace an old drive, and replace an old drive across Cumbria:
