Replacing tarmac or concrete with block paving in Banbridge: the local picture
Banbridge is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
Wet winters in Northern Ireland make falls, edge restraints and full joints especially important.
How much does a replacement block drive cost in Banbridge?
In Northern Ireland, a replacement block drive usually costs £90–£170 per m² including VAT. For a 45 m² replacement drive, that is roughly £4,050–£7,700. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £90–£170 per m² |
| Breaking out an old surface | £9.50–£40 per m² |
| Edging or kerb, bedded and haunched | £19–£50 per metre |
| Typical channel drain run | £330–£950 |
| Dropped kerb (vehicle crossover) construction | £950–£2,850 |
Guide figures for Northern Ireland, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
Before we price your replacement block drive
- Existing manhole and inspection covers, and whether to recess them
- Where an electric vehicle charger cable might run
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Trees and roots near the drive
- Edges against lawns, beds, walls and neighbours
Planning and kerb rules in Banbridge
Banbridge is in Northern Ireland, so these rules apply:
In Northern Ireland, a hard surface between the front of the house and the road that covers or replaces more than 5 m² must be porous or permeable, or drain to a permeable area within the property, to be permitted development.
Hard surfaces within the grounds of a listed building need listed building consent. Planning is handled by your district council, so check with its planning office if you are unsure.
Dropped kerbs in Northern Ireland are approved by DfI Roads (the Department for Infrastructure), not the council; check planning separately with the council.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
Why choose Block Paving Contractors
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Replace an old drive in Banbridge: questions
Do you cover Newry, Warrenpoint and Newcastle?
Yes. We cover Banbridge and the places around it, including Newry, Warrenpoint and Newcastle, and the rest of County Down.
Can you match the blocks to my house in Banbridge?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
Do I need planning permission for a replacement block drive in Banbridge?
In Northern Ireland, front paving over 5 m² must be porous or drain within your boundary to be permitted development. Ask us on the survey if you are unsure.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
Replace an old drive near Banbridge
Nearby towns we cover for replace an old drive, and replace an old drive across County Down:
- Replace an old drive in Newry
- Replace an old drive in Warrenpoint
- Replace an old drive in Newcastle
- Replace an old drive in Carryduff
- Replace an old drive in Downpatrick
