Planning a replacement block drive in Pudsey
Pudsey is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
Yorkshire has everything from stone-built terraces to large new estates, so block choice often follows the house: clay or tumbled blocks for older homes, crisp concrete for newer ones.
How much does a replacement block drive cost in Pudsey?
In Yorkshire and the Humber, a replacement block drive usually costs £85–£160 per m² including VAT. For a 45 m² replacement drive, that is roughly £3,850–£7,300. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £85–£160 per m² |
| Breaking out an old surface | £9–£35 per m² |
| Edging or kerb, bedded and haunched | £18–£45 per metre |
| Typical channel drain run | £320–£900 |
| Dropped kerb (vehicle crossover) construction | £900–£2,700 |
Guide figures for Yorkshire and the Humber, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Drainage added where the old drive sent water to the house or road
- Assessment of the old base: keep, top up or replace
- Break-out of the old surface with waste removal and skip or grab lorry
What we check on a Pudsey survey
- Ground conditions under the old surface and how deep the sub-base must be
- Where an electric vehicle charger cable might run
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Steps, thresholds and door heights
- The kerb: is it already dropped, and is it wide enough?
Planning and kerb rules in Pudsey
Pudsey is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Replace an old drive in Pudsey: questions
Do I need planning permission for a replacement block drive in Pudsey?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Can you match the blocks to my house in Pudsey?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How much does a replacement block drive cost in Pudsey?
Our guide for Pudsey is £85–£160 per m² including VAT, so a 45 m² replacement drive is usually about £3,850–£7,300. Your fixed price follows the survey.
Replace an old drive near Pudsey
Nearby towns we cover for replace an old drive, and replace an old drive across West Yorkshire:
- Replace an old drive in Bradford
- Replace an old drive in Morley
- Replace an old drive in Leeds
- Replace an old drive in Yeadon
- Replace an old drive in Shipley
- Replace an old drive in Cleckheaton
