Replacing tarmac or concrete with block paving in Cleckheaton: the local picture
Homes in Cleckheaton include plenty of semis and detached houses with room for a drive, plus older terraces where parking is tighter.
Sloping drives are common in parts of Yorkshire, which affects falls, steps and drainage at the bottom of the drive.
How much does a replacement block drive cost in Cleckheaton?
For Cleckheaton, our guide is £85–£160 per m² including VAT, so a 45 m² replacement drive is likely to be £3,850–£7,300. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £85–£160 per m² |
| Breaking out an old surface | £9–£35 per m² |
| Edging or kerb, bedded and haunched | £18–£45 per metre |
| Typical channel drain run | £320–£900 |
| Dropped kerb (vehicle crossover) construction | £900–£2,700 |
Guide figures for Yorkshire and the Humber, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Assessment of the old base: keep, top up or replace
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
- Drainage added where the old drive sent water to the house or road
What we check on a Cleckheaton survey
- Access for a mini-digger, skip or grab lorry
- The kerb: is it already dropped, and is it wide enough?
- Ground conditions under the old surface and how deep the sub-base must be
- Edges against lawns, beds, walls and neighbours
- Trees and roots near the drive
Do you need permission in Cleckheaton?
Cleckheaton is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Why choose Block Paving Contractors
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Replace an old drive in Cleckheaton: questions
Is the survey in Cleckheaton free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Can you match the blocks to my house in Cleckheaton?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How much does a replacement block drive cost in Cleckheaton?
Our guide for Cleckheaton is £85–£160 per m² including VAT, so a 45 m² replacement drive is usually about £3,850–£7,300. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in Cleckheaton?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Replace an old drive near Cleckheaton
Nearby towns we cover for replace an old drive, and replace an old drive across West Yorkshire:
- Replace an old drive in Brighouse
- Replace an old drive in Dewsbury
- Replace an old drive in Morley
- Replace an old drive in Bradford
- Replace an old drive in Pudsey
- Replace an old drive in Halifax
