England · Replace an old drive

Replacing tarmac or concrete with block paving in Warwickshire

Block paving suits homes in Warwickshire because it can be repaired a block at a time and looks right for decades when the base underneath is built properly.

  • 7 towns listed
  • £95–£180 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

How much does a replacement block drive cost in Warwickshire?

Guide price in Warwickshire£95–£180 per m²Including VAT at 20%

Most replacement block drive quotes in the West Midlands fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£95–£180 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the West Midlands, checked 9 November 2026.

Towns we cover in Warwickshire

Choose a town for local prices and details for replace an old drive:

What does a replacement block drive involve?

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

Inter-war semis with narrow front gardens are common in the West Midlands, so front garden conversions and drive widenings are often the practical choice.

  • Break-out of the old surface with waste removal and skip or grab lorry
  • Assessment of the old base: keep, top up or replace
  • Drainage added where the old drive sent water to the house or road
  • Levels set below the damp-proof course with falls away from the house
  • New edging, sub-base where needed, and the block drive

What the survey covers

  • Where rain will go: falls, lawn, border, channel or soakaway
  • Access for a mini-digger, skip or grab lorry
  • Whether front-garden planning rules apply
  • Steps, thresholds and door heights
  • Ground conditions under the old surface and how deep the sub-base must be

Rules for front drives in Warwickshire

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

Replace an old drive in Warwickshire: questions

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Nuneaton, Rugby and Leamington Spa?

Yes. We cover all of Warwickshire, including Nuneaton, Rugby and Leamington Spa.

How much does a replacement block drive cost in Warwickshire?

Our guide for Warwickshire is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Neighbouring areas

Next step

Get a guide price in two minutes

Answer four quick questions for an instant guide price, then book a free survey to fix it in writing. Repairs and cleaning can often be priced from photos.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote