What to know before a replacement block drive in Epsom
Homes in Epsom include plenty of semis and detached houses with room for a drive, plus older terraces where parking is tighter.
Planning-sensitive towns and conservation areas are common in the South East, so we check the front-garden rules before quoting.
How much does a replacement block drive cost in Epsom?
Guide price in Epsom: £105–£195 per m² including VAT, which puts a 45 m² replacement drive at about £4,600–£8,750. These are South East guide figures; the survey confirms the real price before you commit.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £105–£195 per m² |
| Breaking out an old surface | £11–£45 per m² |
| Edging or kerb, bedded and haunched | £20–£55 per metre |
| Typical channel drain run | £380–£1,100 |
| Dropped kerb (vehicle crossover) construction | £1,100–£3,250 |
Guide figures for the South East, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
- Drainage added where the old drive sent water to the house or road
- Assessment of the old base: keep, top up or replace
Before we price your replacement block drive
- Steps, thresholds and door heights
- Where an electric vehicle charger cable might run
- The kerb: is it already dropped, and is it wide enough?
- Edges against lawns, beds, walls and neighbours
- Access for a mini-digger, skip or grab lorry
Planning and kerb rules in Epsom
Epsom is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Replace an old drive in Epsom: questions
Do you cover Ewell, Banstead and Leatherhead?
Yes. We cover Epsom and the places around it, including Ewell, Banstead and Leatherhead, and the rest of Surrey.
Do I need planning permission for a replacement block drive in Epsom?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Is the survey in Epsom free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How much does a replacement block drive cost in Epsom?
Our guide for Epsom is £105–£195 per m² including VAT, so a 45 m² replacement drive is usually about £4,600–£8,750. Your fixed price follows the survey.
Replace an old drive near Epsom
Nearby towns we cover for replace an old drive, and replace an old drive across Surrey:
- Replace an old drive in Ewell
- Replace an old drive in Banstead
- Replace an old drive in Leatherhead
- Replace an old drive in Esher
- Replace an old drive in Reigate
- Replace an old drive in Walton-on-Thames
