Replacing tarmac or concrete with block paving in Erskine: the local picture
Around Erskine, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Erskine?
Guide price in Erskine: £95–£180 per m² including VAT, which puts a 45 m² replacement drive at about £4,300–£8,100. These are Scotland guide figures; the survey confirms the real price before you commit.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
What we check on an Erskine survey
- Ground conditions under the old surface and how deep the sub-base must be
- Block range, thickness, colour and pattern to suit the house
- Where rain will go: falls, lawn, border, channel or soakaway
- Edges against lawns, beds, walls and neighbours
- The kerb: is it already dropped, and is it wide enough?
Do you need permission in Erskine?
Erskine is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Erskine: questions
How much does a replacement block drive cost in Erskine?
Our guide for Erskine is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Can you match the blocks to my house in Erskine?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
Do you cover Renfrew, Paisley and Johnstone?
Yes. We cover Erskine and the places around it, including Renfrew, Paisley and Johnstone, and the rest of Renfrewshire and Inverclyde.
Replace an old drive near Erskine
Nearby towns we cover for replace an old drive, and replace an old drive across Renfrewshire and Inverclyde:
- Replace an old drive in Renfrew
- Replace an old drive in Paisley
- Replace an old drive in Johnstone
- Replace an old drive in Barrhead
- Replace an old drive in Giffnock
- Replace an old drive in Port Glasgow
