Nottinghamshire · Replace an old drive

Replacing tarmac or concrete with block paving in Retford

If you are in Retford (DN22, DN10) and want a replacement block drive, we will come out, measure up and give you a fixed written price once the specification is agreed.

  • Postcodes DN22, DN10
  • £95–£180 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Retford

In and around Retford, village-style frontages sit alongside newer cul-de-sacs, so the right block often depends on the age of the house.

Clay and mudstone ground is common in the East Midlands, so we allow for a deeper sub-base where the survey shows soft ground.

How much does a replacement block drive cost in Retford?

Guide price in Retford£95–£180 per m²Including VAT at 20%

Most replacement block drive quotes in the East Midlands fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£95–£180 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the East Midlands, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Levels set below the damp-proof course with falls away from the house
  • Assessment of the old base: keep, top up or replace
  • Drainage added where the old drive sent water to the house or road
  • Break-out of the old surface with waste removal and skip or grab lorry
  • New edging, sub-base where needed, and the block drive

What we check on a Retford survey

  • Edges against lawns, beds, walls and neighbours
  • Where an electric vehicle charger cable might run
  • Where rain will go: falls, lawn, border, channel or soakaway
  • Trees and roots near the drive
  • Steps, thresholds and door heights

Do you need permission in Retford?

Retford is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

What you can expect from us

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Replace an old drive in Retford: questions

How much does a replacement block drive cost in Retford?

Our guide for Retford is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.

Do I need planning permission for a replacement block drive in Retford?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Is the survey in Retford free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Replace an old drive near Retford

Nearby towns we cover for replace an old drive, and replace an old drive across Nottinghamshire:

Other block paving services in Retford

Or see all block paving services in Retford.

Next step

Get a guide price in two minutes

Get a guide price in a couple of minutes with our quote tool, or book a survey in Retford.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote