What to know before a replacement block drive in Stamford Hill
Stamford Hill has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.
Front gardens in much of London are short, so parking depth and the dropped kerb usually decide whether a drive is possible.
How much does a replacement block drive cost in Stamford Hill?
In London, a replacement block drive usually costs £115–£215 per m² including VAT. For a 45 m² replacement drive, that is roughly £5,150–£9,700. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £115–£215 per m² |
| Breaking out an old surface | £12–£50 per m² |
| Edging or kerb, bedded and haunched | £25–£60 per metre |
| Typical channel drain run | £420–£1,200 |
| Dropped kerb (vehicle crossover) construction | £1,200–£3,600 |
Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Drainage added where the old drive sent water to the house or road
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
What we check on a Stamford Hill survey
- Trees and roots near the drive
- Ground conditions under the old surface and how deep the sub-base must be
- Steps, thresholds and door heights
- Where rain will go: falls, lawn, border, channel or soakaway
- Where an electric vehicle charger cable might run
Rules for front drives in Stamford Hill
Stamford Hill is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
Why choose Block Paving Contractors
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Stamford Hill: questions
Do I need planning permission for a replacement block drive in Stamford Hill?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Do you cover Tottenham, Holloway and Islington?
Yes. We cover Stamford Hill and the places around it, including Tottenham, Holloway and Islington, and the rest of Greater London.
Replace an old drive near Stamford Hill
Nearby towns we cover for replace an old drive, and replace an old drive across Greater London:
- Replace an old drive in Tottenham
- Replace an old drive in Holloway
- Replace an old drive in Islington
- Replace an old drive in Walthamstow
- Replace an old drive in Leytonstone
- Replace an old drive in Edmonton
