How much does a replacement block drive cost in Forth Valley?
In Scotland, a replacement block drive usually costs £95–£180 per m² including VAT. For a 45 m² replacement drive, that is roughly £4,300–£8,100. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026.
Towns we cover in Forth Valley
Choose a town for local prices and details for replace an old drive:
What does a replacement block drive involve?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.
- Levels set below the damp-proof course with falls away from the house
- Drainage added where the old drive sent water to the house or road
- Assessment of the old base: keep, top up or replace
- Break-out of the old surface with waste removal and skip or grab lorry
- New edging, sub-base where needed, and the block drive
What the survey covers
- Trees and roots near the drive
- Existing manhole and inspection covers, and whether to recess them
- Ground conditions under the old surface and how deep the sub-base must be
- Edges against lawns, beds, walls and neighbours
- Steps, thresholds and door heights
Rules for front drives in Forth Valley
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Send the basics
Postcode, what you need and a rough size. Photos help.
Survey
We measure, check levels, ground and drainage, and talk through blocks and patterns.
Written quote
An itemised quote with the specification, the price and the start date.
The work
Our paving team builds it to the agreed specification and leaves the site swept.
Replace an old drive in Forth Valley: questions
Do you cover Stirling, Falkirk and Alloa?
Yes. We cover all of the Forth Valley, including Stirling, Falkirk and Alloa.
How much does a replacement block drive cost in Forth Valley?
Our guide for Forth Valley is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in Forth Valley?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
