What to know before a replacement block drive in Dalgety Bay
In and around Dalgety Bay, village-style frontages sit alongside newer cul-de-sacs, so the right block often depends on the age of the house.
Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Dalgety Bay?
Most replacement block drive quotes in Scotland fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Break-out of the old surface with waste removal and skip or grab lorry
Before we price your replacement block drive
- Trees and roots near the drive
- Ground conditions under the old surface and how deep the sub-base must be
- Access for a mini-digger, skip or grab lorry
- Steps, thresholds and door heights
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
Rules for front drives in Dalgety Bay
Dalgety Bay is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Replace an old drive in Dalgety Bay: questions
Can you match the blocks to my house in Dalgety Bay?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How much does a replacement block drive cost in Dalgety Bay?
Our guide for Dalgety Bay is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in Dalgety Bay?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Replace an old drive near Dalgety Bay
Nearby towns we cover for replace an old drive, and replace an old drive across Fife:
- Replace an old drive in Rosyth
- Replace an old drive in Dunfermline
- Replace an old drive in Cowdenbeath
- Replace an old drive in Kirkcaldy
- Replace an old drive in Glenrothes
- Replace an old drive in Methil
