Essex · Replace an old drive

Replacing tarmac or concrete with block paving in Harlow

If you are in Harlow (CM20, CM18, CM17, CM19) and want a replacement block drive, we will come out, measure up and give you a fixed written price once the specification is agreed.

  • Postcodes CM20, CM18, CM17
  • £100–£190 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Harlow

Across Harlow, front gardens range from narrow terrace plots to broad modern drives, and the best block, pattern and drainage choice changes with them.

Clay soils are common in parts of the East of England, so drainage and sub-base depth get extra attention.

How much does a replacement block drive cost in Harlow?

Guide price in Harlow£100–£190 per m²Including VAT at 20%

Most replacement block drive quotes in the East of England fall within £100–£190 per m² including VAT. A 45 m² replacement drive would usually be about £4,500–£8,500, with any extras listed separately on your quote.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£100–£190 per m²
Breaking out an old surface£11–£40 per m²
Edging or kerb, bedded and haunched£20–£55 per metre
Typical channel drain run£370–£1,050
Dropped kerb (vehicle crossover) construction£1,050–£3,150

Guide figures for the East of England, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Break-out of the old surface with waste removal and skip or grab lorry
  • New edging, sub-base where needed, and the block drive
  • Assessment of the old base: keep, top up or replace
  • Levels set below the damp-proof course with falls away from the house
  • Drainage added where the old drive sent water to the house or road

What we check on a Harlow survey

  • The kerb: is it already dropped, and is it wide enough?
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Access for a mini-digger, skip or grab lorry
  • Trees and roots near the drive
  • Existing manhole and inspection covers, and whether to recess them

Do you need permission in Harlow?

Harlow is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

What you can expect from us

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Replace an old drive in Harlow: questions

How much does a replacement block drive cost in Harlow?

Our guide for Harlow is £100–£190 per m² including VAT, so a 45 m² replacement drive is usually about £4,500–£8,500. Your fixed price follows the survey.

Is the survey in Harlow free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Waltham Abbey, Loughton and Brentwood?

Yes. We cover Harlow and the places around it, including Waltham Abbey, Loughton and Brentwood, and the rest of Essex.

Replace an old drive near Harlow

Nearby towns we cover for replace an old drive, and replace an old drive across Essex:

Other block paving services in Harlow

Or see all block paving services in Harlow.

Next step

Get a guide price in two minutes

Ready to talk about your replacement block drive? Send your postcode and a few details, and we will arrange the next step.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote