Planning a replacement block drive in Seaford
Around Seaford, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.
Chalk, clay and sandy ground all occur across the South East, so the dig and sub-base depth are set on the survey rather than assumed.
How much does a replacement block drive cost in Seaford?
In the South East, a replacement block drive usually costs £105–£195 per m² including VAT. For a 45 m² replacement drive, that is roughly £4,600–£8,750. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £105–£195 per m² |
| Breaking out an old surface | £11–£45 per m² |
| Edging or kerb, bedded and haunched | £20–£55 per metre |
| Typical channel drain run | £380–£1,100 |
| Dropped kerb (vehicle crossover) construction | £1,100–£3,250 |
Guide figures for the South East, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Drainage added where the old drive sent water to the house or road
- Assessment of the old base: keep, top up or replace
Before we price your replacement block drive
- Existing manhole and inspection covers, and whether to recess them
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Block range, thickness, colour and pattern to suit the house
- Steps, thresholds and door heights
- Access for a mini-digger, skip or grab lorry
Do you need permission in Seaford?
Seaford is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
What you can expect from us
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Seaford: questions
Do you cover Rottingdean, Eastbourne and Hailsham?
Yes. We cover Seaford and the places around it, including Rottingdean, Eastbourne and Hailsham, and the rest of East Sussex.
Is the survey in Seaford free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Do I need planning permission for a replacement block drive in Seaford?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Replace an old drive near Seaford
Nearby towns we cover for replace an old drive, and replace an old drive across East Sussex:
- Replace an old drive in Rottingdean
- Replace an old drive in Eastbourne
- Replace an old drive in Hailsham
- Replace an old drive in Brighton
- Replace an old drive in Hove
- Replace an old drive in Portslade
