What to know before a permeable block drive in Auchterarder
Auchterarder is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a permeable block drive cost in Auchterarder?
Most permeable block drive quotes in Scotland fall within £105–£170 per m² including VAT. A 50 m² drive would usually be about £5,250–£8,500, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Permeable block paving driveway | £105–£170 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Permeable block paving is block paving built so that rainwater drains down through the joints into a deep, open-graded stone sub-base, where it is stored and soaks away slowly into the ground or is piped off. The blocks have small spacers or wider joints filled with fine grit instead of sand.
- Ground check: how well the soil drains and how high the water table sits
- Open-graded crushed stone (no fines) laid and compacted in layers
- Geotextile layer where the design needs one
- Deeper dig-out for the open-graded sub-base
- Grit laying course and permeable blocks with grit-filled joints
Before we price your permeable block drive
- Edges against lawns, beds, walls and neighbours
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- The kerb: is it already dropped, and is it wide enough?
- Steps, thresholds and door heights
- Trees and roots near the drive
Rules for front drives in Auchterarder
Auchterarder is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Permeable paving in Auchterarder: questions
Do I need planning permission for a permeable block drive in Auchterarder?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
Do you cover Crieff, Perth and Scone?
Yes. We cover Auchterarder and the places around it, including Crieff, Perth and Scone, and the rest of Perth and Kinross.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How long does a permeable block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Permeable paving near Auchterarder
Nearby towns we cover for permeable paving, and permeable paving across Perth and Kinross:
- Permeable paving in Crieff
- Permeable paving in Perth
- Permeable paving in Scone
- Permeable paving in Blairgowrie
