Greater London · Permeable paving

Permeable block paving in Battersea

If you are in Battersea (SW11, SW8, SW3, SW4) and want a permeable block drive, we will come out, measure up and give you a fixed written price once the specification is agreed.

  • Postcodes SW11, SW8, SW3
  • £125–£205 per m² inc VAT
  • Free survey for new paving
Grey permeable block paving with grit-filled joints soaking up rain on a driveway

What to know before a permeable block drive in Battersea

Battersea has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.

Many London streets have controlled parking and narrow frontages, so we measure the car space and the crossover before anything else.

How much does a permeable block drive cost in Battersea?

Guide price in Battersea£125–£205 per m²Including VAT at 20%

Expect permeable block drives in Battersea to come in at around £125–£205 per m², including VAT at 20%. As an example, a 50 m² drive usually comes to between £6,300 and £10,200.

ItemGuide price inc VAT
Permeable block paving driveway£125–£205 per m²
Breaking out an old surface£12–£50 per m²
Edging or kerb, bedded and haunched£25–£60 per metre
Typical channel drain run£420–£1,200
Dropped kerb (vehicle crossover) construction£1,200–£3,600

Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our permeable paving service

Permeable block paving is block paving built so that rainwater drains down through the joints into a deep, open-graded stone sub-base, where it is stored and soaks away slowly into the ground or is piped off. The blocks have small spacers or wider joints filled with fine grit instead of sand.

  • Geotextile layer where the design needs one
  • Grit laying course and permeable blocks with grit-filled joints
  • Ground check: how well the soil drains and how high the water table sits
  • Open-graded crushed stone (no fines) laid and compacted in layers
  • Edge restraints and any overflow or outlet the design needs

What we check on a Battersea survey

  • Steps, thresholds and door heights
  • Ground conditions under the old surface and how deep the sub-base must be
  • Existing manhole and inspection covers, and whether to recess them
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Where an electric vehicle charger cable might run

Rules for front drives in Battersea

Battersea is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

What you can expect from us

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Permeable paving in Battersea: questions

Do I need planning permission for a permeable block drive in Battersea?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Do you cover Fulham, Brixton and Putney?

Yes. We cover Battersea and the places around it, including Fulham, Brixton and Putney, and the rest of Greater London.

Is the survey in Battersea free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Can you match the blocks to my house in Battersea?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

Permeable paving near Battersea

Nearby towns we cover for permeable paving, and permeable paving across Greater London:

Other block paving services in Battersea

Or see all block paving services in Battersea.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote