What to know before a driveway extension in Bridgwater
Bridgwater is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
The South West is wetter than the east of England, so falls and drainage are planned before the pattern is chosen.
How much does a driveway extension cost in Bridgwater?
In the South West, a driveway extension usually costs £90–£150 per m² including VAT. For a 15 m² extension, that is roughly £1,550–£2,600. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Driveway extension in block paving | £90–£150 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the South West, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our drive extensions service
The hard part is the join. Blocks from the same range can differ in shade from a batch made years ago, and older blocks have weathered, so the survey looks at whether a close match is possible, whether lifting and re-mixing some existing blocks will help, or whether a deliberate border or contrasting panel will look better than a near-miss.
- Joint sand, compaction and a clean-down of the old section
- Dig-out and sub-base for the new area
- New edging, kerbs or a low retaining edge where the lawn is cut back
- Old edge restraint taken out and the new paving toothed into the old pattern
- Check of the existing drive: block range, thickness, levels and condition
What the survey covers
- Steps, thresholds and door heights
- Edges against lawns, beds, walls and neighbours
- Where an electric vehicle charger cable might run
- Access for a mini-digger, skip or grab lorry
- Ground conditions under the old surface and how deep the sub-base must be
Planning and kerb rules in Bridgwater
Bridgwater is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
What you can expect from us
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
One point of contact
You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Drive extensions in Bridgwater: questions
How much does a driveway extension cost in Bridgwater?
Our guide for Bridgwater is £90–£150 per m² including VAT, so a 15 m² extension is usually about £1,550–£2,600. Your fixed price follows the survey.
Can you match the blocks to my house in Bridgwater?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
Do you cover Burnham-on-Sea, Taunton and Weston-super-Mare?
Yes. We cover Bridgwater and the places around it, including Burnham-on-Sea, Taunton and Weston-super-Mare, and the rest of Somerset.
How long does a driveway extension take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Drive extensions near Bridgwater
Nearby towns we cover for drive extensions, and drive extensions across Somerset:
- Drive extensions in Burnham-on-Sea
- Drive extensions in Taunton
- Drive extensions in Weston-super-Mare
- Drive extensions in Yeovil
- Drive extensions in Clevedon
- Drive extensions in Nailsea
