How much does a block paved driveway cost in Lanarkshire?
Most block paved driveway quotes in Scotland fall within £85–£140 per m² including VAT. A 50 m² double drive would usually be about £4,250–£7,000, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Concrete block driveway, new sub-base | £85–£140 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026.
Towns we cover in Lanarkshire
Choose a town for local prices and details for block paved driveways:
- East Kilbride
- Hamilton
- Cumbernauld
- Coatbridge
- Airdrie
- Motherwell
- Cambuslang
- Wishaw
- Bellshill
- Blantyre
- Larkhall
- Carluke
- Kilsyth
What is included?
A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.
Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.
- Edge restraints or kerbs bedded and haunched in concrete
- Crushed-stone sub-base laid in layers and compacted
- Cuts at edges, around covers and against the house
- Survey, measurements and a written, itemised quote
- Sharp-sand laying course screeded to falls
What the survey covers
- Steps, thresholds and door heights
- Edges against lawns, beds, walls and neighbours
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- The kerb: is it already dropped, and is it wide enough?
- Ground conditions under the old surface and how deep the sub-base must be
Rules for front drives in Lanarkshire
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
Block paved driveways in Lanarkshire: questions
Do I need planning permission for a block paved driveway in Lanarkshire?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
Can you match the blocks to my house in Lanarkshire?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How much does a block paved driveway cost in Lanarkshire?
Our guide for Lanarkshire is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.
Is the survey in Lanarkshire free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
