Lanarkshire · Block paved driveways

Block paving driveways in Hamilton

Planning a block paved driveway in Hamilton? Start with a free survey: we check levels against the damp-proof course, the ground, the drainage and the kerb before pricing anything.

  • Postcodes ML3, ML10
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Planning a block paved driveway in Hamilton

Homes in Hamilton include plenty of semis and detached houses with room for a drive, plus older terraces where parking is tighter.

Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a block paved driveway cost in Hamilton?

Guide price in Hamilton£85–£140 per m²Including VAT at 20%

In Scotland, a block paved driveway usually costs £85–£140 per m² including VAT. For a 50 m² double drive, that is roughly £4,250–£7,000. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.

  • Sharp-sand laying course screeded to falls
  • Blocks laid in your chosen pattern, with a contrasting border if wanted
  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Removal of the old surface and soil to the agreed depth, with waste taken away
  • Cuts at edges, around covers and against the house

What we check on a Hamilton survey

  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Existing manhole and inspection covers, and whether to recess them
  • Steps, thresholds and door heights
  • Access for a mini-digger, skip or grab lorry
  • Where rain will go: falls, lawn, border, channel or soakaway

Planning and kerb rules in Hamilton

Hamilton is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

How we work

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Block paved driveways in Hamilton: questions

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

How much does a block paved driveway cost in Hamilton?

Our guide for Hamilton is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.

How long does a block paved driveway take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Is the survey in Hamilton free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Block paved driveways near Hamilton

Nearby towns we cover for block paved driveways, and block paved driveways across Lanarkshire:

Other block paving services in Hamilton

Or see all block paving services in Hamilton.

Next step

Get a guide price in two minutes

Get a guide price in a couple of minutes with our quote tool, or book a survey in Hamilton.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote