Glasgow and Dunbartonshire · Block paved driveways

Block paving driveways in Bishopbriggs

Block paving driveways in Bishopbriggs: built on a properly dug and compacted base, edged in concrete and laid to falls that take water away from the house.

  • Postcodes G64, G22, G21
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Block paving driveways in Bishopbriggs: the local picture

Bishopbriggs is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.

In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a block paved driveway cost in Bishopbriggs?

Guide price in Bishopbriggs£85–£140 per m²Including VAT at 20%

Expect block paved driveways in Bishopbriggs to come in at around £85–£140 per m², including VAT at 20%. As an example, a 50 m² double drive usually comes to between £4,250 and £7,000.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What does a block paved driveway involve?

A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.

  • Cuts at edges, around covers and against the house
  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Blocks laid in your chosen pattern, with a contrasting border if wanted
  • Removal of the old surface and soil to the agreed depth, with waste taken away
  • Edge restraints or kerbs bedded and haunched in concrete

Before we price your block paved driveway

  • Where an electric vehicle charger cable might run
  • Whether front-garden planning rules apply
  • Ground conditions under the old surface and how deep the sub-base must be
  • Edges against lawns, beds, walls and neighbours
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)

Planning and kerb rules in Bishopbriggs

Bishopbriggs is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

How we work

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Block paved driveways in Bishopbriggs: questions

How much does a block paved driveway cost in Bishopbriggs?

Our guide for Bishopbriggs is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.

How long does a block paved driveway take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Do you cover Kirkintilloch, Bearsden and Milngavie?

Yes. We cover Bishopbriggs and the places around it, including Kirkintilloch, Bearsden and Milngavie, and the rest of Glasgow and Dunbartonshire.

Do I need planning permission for a block paved driveway in Bishopbriggs?

In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.

Block paved driveways near Bishopbriggs

Nearby towns we cover for block paved driveways, and block paved driveways across Glasgow and Dunbartonshire:

Other block paving services in Bishopbriggs

Or see all block paving services in Bishopbriggs.

Next step

Get a guide price in two minutes

Get a guide price in a couple of minutes with our quote tool, or book a survey in Bishopbriggs.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote