Dorset · Block paved driveways

Block paving driveways in Poole

Block paving suits homes in Poole because it can be repaired a block at a time and looks right for decades when the base underneath is built properly.

  • Postcodes BH15, BH14, BH17
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Planning a block paved driveway in Poole

Across Poole, front gardens range from narrow terrace plots to broad modern drives, and the best block, pattern and drainage choice changes with them.

Sloping plots are common in the South West, which affects edging, steps and where the water runs.

How much does a block paved driveway cost in Poole?

Guide price in Poole£85–£140 per m²Including VAT at 20%

Guide price in Poole: £85–£140 per m² including VAT, which puts a 50 m² double drive at about £4,250–£7,000. These are South West guide figures; the survey confirms the real price before you commit.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the South West, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.

  • Blocks laid in your chosen pattern, with a contrasting border if wanted
  • Edge restraints or kerbs bedded and haunched in concrete
  • Cuts at edges, around covers and against the house
  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Sharp-sand laying course screeded to falls

What the survey covers

  • Trees and roots near the drive
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Where rain will go: falls, lawn, border, channel or soakaway
  • The kerb: is it already dropped, and is it wide enough?
  • Existing manhole and inspection covers, and whether to recess them

Planning and kerb rules in Poole

Poole is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

Why choose Block Paving Contractors

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Block paved driveways in Poole: questions

How long does a block paved driveway take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Do I need planning permission for a block paved driveway in Poole?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Bournemouth, Ferndown and Christchurch?

Yes. We cover Poole and the places around it, including Bournemouth, Ferndown and Christchurch, and the rest of Dorset.

Block paved driveways near Poole

Nearby towns we cover for block paved driveways, and block paved driveways across Dorset:

Other block paving services in Poole

Or see all block paving services in Poole.

Next step

Get a guide price in two minutes

Tell us what you have in mind for Poole, and we will put a written price together.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote