Dorset · Block paved driveways

Block paving driveways in Ferndown

Planning a block paved driveway in Ferndown? Start with a free survey: we check levels against the damp-proof course, the ground, the drainage and the kerb before pricing anything.

  • Postcodes BH22, BH21, BH31
  • £85–£140 per m² inc VAT
  • Free survey for new paving
Silver-grey herringbone block paved driveway with a charcoal border in front of a detached house

Block paving driveways in Ferndown: the local picture

Around Ferndown, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.

Sloping plots are common in the South West, which affects edging, steps and where the water runs.

How much does a block paved driveway cost in Ferndown?

Guide price in Ferndown£85–£140 per m²Including VAT at 20%

For Ferndown, our guide is £85–£140 per m² including VAT, so a 50 m² double drive is likely to be £4,250–£7,000. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.

ItemGuide price inc VAT
Concrete block driveway, new sub-base£85–£140 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the South West, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our block paved driveways service

We build block drives for homeowners from scratch: digging out the old surface, setting edge restraints in concrete, building and compacting the sub-base, screeding the laying course, laying the pattern, cutting in the edges and vibrating the blocks into the sand. Every quote states the depth of dig, the sub-base thickness, the edging, the falls and where the water goes.

  • Kiln-dried sand brushed in and the surface vibrated with a plate compactor
  • Removal of the old surface and soil to the agreed depth, with waste taken away
  • Crushed-stone sub-base laid in layers and compacted
  • Sharp-sand laying course screeded to falls
  • Survey, measurements and a written, itemised quote

What we check on a Ferndown survey

  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Where an electric vehicle charger cable might run
  • Where rain will go: falls, lawn, border, channel or soakaway
  • Access for a mini-digger, skip or grab lorry
  • Ground conditions under the old surface and how deep the sub-base must be

Rules for front drives in Ferndown

Ferndown is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

What you can expect from us

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Block paved driveways in Ferndown: questions

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

How much does a block paved driveway cost in Ferndown?

Our guide for Ferndown is £85–£140 per m² including VAT, so a 50 m² double drive is usually about £4,250–£7,000. Your fixed price follows the survey.

Do I need planning permission for a block paved driveway in Ferndown?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Do you cover Bournemouth, Christchurch and Poole?

Yes. We cover Ferndown and the places around it, including Bournemouth, Christchurch and Poole, and the rest of Dorset.

Block paved driveways near Ferndown

Nearby towns we cover for block paved driveways, and block paved driveways across Dorset:

Other block paving services in Ferndown

Or see all block paving services in Ferndown.

Next step

Get a guide price in two minutes

Call, WhatsApp or use the form, and we will come back to you to arrange a visit or a price from photos.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote