Replacing tarmac or concrete with block paving in Wellington: the local picture
Wellington is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
Inter-war semis with narrow front gardens are common in the West Midlands, so front garden conversions and drive widenings are often the practical choice.
How much does a replacement block drive cost in Wellington?
Expect replacement block drives in Wellington to come in at around £95–£180 per m², including VAT at 20%. As an example, a 45 m² replacement drive usually comes to between £4,300 and £8,100.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the West Midlands, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
What we check on a Wellington survey
- The kerb: is it already dropped, and is it wide enough?
- Trees and roots near the drive
- Existing manhole and inspection covers, and whether to recess them
- Where an electric vehicle charger cable might run
- Block range, thickness, colour and pattern to suit the house
Do you need permission in Wellington?
Wellington is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Replace an old drive in Wellington: questions
Do I need planning permission for a replacement block drive in Wellington?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Can you match the blocks to my house in Wellington?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How much does a replacement block drive cost in Wellington?
Our guide for Wellington is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
Replace an old drive near Wellington
Nearby towns we cover for replace an old drive, and replace an old drive across Shropshire:
- Replace an old drive in Hadley
- Replace an old drive in Telford
- Replace an old drive in Newport, Shropshire
- Replace an old drive in Shrewsbury
