Oxfordshire · Replace an old drive

Replacing tarmac or concrete with block paving in Bicester

Planning a replacement block drive in Bicester? Start with a free survey: we check levels against the damp-proof course, the ground, the drainage and the kerb before pricing anything.

  • Postcodes OX26, OX6, OX25
  • £105–£195 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Bicester

Bicester is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.

Chalk, clay and sandy ground all occur across the South East, so the dig and sub-base depth are set on the survey rather than assumed.

How much does a replacement block drive cost in Bicester?

Guide price in Bicester£105–£195 per m²Including VAT at 20%

Guide price in Bicester: £105–£195 per m² including VAT, which puts a 45 m² replacement drive at about £4,600–£8,750. These are South East guide figures; the survey confirms the real price before you commit.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£105–£195 per m²
Breaking out an old surface£11–£45 per m²
Edging or kerb, bedded and haunched£20–£55 per metre
Typical channel drain run£380–£1,100
Dropped kerb (vehicle crossover) construction£1,100–£3,250

Guide figures for the South East, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Levels set below the damp-proof course with falls away from the house
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Drainage added where the old drive sent water to the house or road
  • New edging, sub-base where needed, and the block drive
  • Assessment of the old base: keep, top up or replace

What the survey covers

  • Block range, thickness, colour and pattern to suit the house
  • Edges against lawns, beds, walls and neighbours
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • The kerb: is it already dropped, and is it wide enough?
  • Steps, thresholds and door heights

Planning and kerb rules in Bicester

Bicester is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

Why choose Block Paving Contractors

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

One point of contact

You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.

Replace an old drive in Bicester: questions

How much does a replacement block drive cost in Bicester?

Our guide for Bicester is £105–£195 per m² including VAT, so a 45 m² replacement drive is usually about £4,600–£8,750. Your fixed price follows the survey.

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Oxford, Banbury and Witney?

Yes. We cover Bicester and the places around it, including Oxford, Banbury and Witney, and the rest of Oxfordshire.

Replace an old drive near Bicester

Nearby towns we cover for replace an old drive, and replace an old drive across Oxfordshire:

Other block paving services in Bicester

Or see all block paving services in Bicester.

Next step

Get a guide price in two minutes

Tell us what you have in mind for Bicester, and we will put a written price together.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote