Replacing tarmac or concrete with block paving in Birkenhead: the local picture
Across Birkenhead, front gardens range from narrow terrace plots to broad modern drives, and the best block, pattern and drainage choice changes with them.
The North West is one of the wetter parts of England, so falls, channel drains and permeable options matter more than usual.
How much does a replacement block drive cost in Birkenhead?
For Birkenhead, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the North West, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
What we check on a Birkenhead survey
- Steps, thresholds and door heights
- Edges against lawns, beds, walls and neighbours
- Block range, thickness, colour and pattern to suit the house
- Access for a mini-digger, skip or grab lorry
- Ground conditions under the old surface and how deep the sub-base must be
Do you need permission in Birkenhead?
Birkenhead is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
Why choose Block Paving Contractors
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Replace an old drive in Birkenhead: questions
How much does a replacement block drive cost in Birkenhead?
Our guide for Birkenhead is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Is the survey in Birkenhead free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Can you match the blocks to my house in Birkenhead?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
Replace an old drive near Birkenhead
Nearby towns we cover for replace an old drive, and replace an old drive across Merseyside:
- Replace an old drive in Liverpool
- Replace an old drive in Wallasey
- Replace an old drive in Bebington
- Replace an old drive in Bootle
- Replace an old drive in Heswall
- Replace an old drive in Garston
