Replacing tarmac or concrete with block paving in Lincoln: the local picture
Lincoln has everything from short terrace frontages to wide drives on newer estates, so the survey sets the layout and the dig.
Clay and mudstone ground is common in the East Midlands, so we allow for a deeper sub-base where the survey shows soft ground.
How much does a replacement block drive cost in Lincoln?
In the East Midlands, a replacement block drive usually costs £95–£180 per m² including VAT. For a 45 m² replacement drive, that is roughly £4,300–£8,100. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for the East Midlands, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
What we check on a Lincoln survey
- Existing manhole and inspection covers, and whether to recess them
- Access for a mini-digger, skip or grab lorry
- Trees and roots near the drive
- Block range, thickness, colour and pattern to suit the house
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
Rules for front drives in Lincoln
Lincoln is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Replace an old drive in Lincoln: questions
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Is the survey in Lincoln free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How much does a replacement block drive cost in Lincoln?
Our guide for Lincoln is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Replace an old drive near Lincoln
Nearby towns we cover for replace an old drive, and replace an old drive across Lincolnshire:
- Replace an old drive in Gainsborough
- Replace an old drive in Grantham
- Replace an old drive in Scunthorpe
