Planning a replacement block drive in Blantyre
Blantyre is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Blantyre?
Most replacement block drive quotes in Scotland fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What does a replacement block drive involve?
Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
Before we price your replacement block drive
- The kerb: is it already dropped, and is it wide enough?
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Block range, thickness, colour and pattern to suit the house
- Access for a mini-digger, skip or grab lorry
- Ground conditions under the old surface and how deep the sub-base must be
Do you need permission in Blantyre?
Blantyre is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Blantyre: questions
Do you cover Cambuslang, Bellshill and East Kilbride?
Yes. We cover Blantyre and the places around it, including Cambuslang, Bellshill and East Kilbride, and the rest of Lanarkshire.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
How much does a replacement block drive cost in Blantyre?
Our guide for Blantyre is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in Blantyre?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
Replace an old drive near Blantyre
Nearby towns we cover for replace an old drive, and replace an old drive across Lanarkshire:
- Replace an old drive in Cambuslang
- Replace an old drive in Bellshill
- Replace an old drive in East Kilbride
- Replace an old drive in Hamilton
- Replace an old drive in Motherwell
- Replace an old drive in Coatbridge
