What to know before a replacement block drive in Andover
Andover is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
Planning-sensitive towns and conservation areas are common in the South East, so we check the front-garden rules before quoting.
How much does a replacement block drive cost in Andover?
For Andover, our guide is £105–£195 per m² including VAT, so a 45 m² replacement drive is likely to be £4,600–£8,750. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £105–£195 per m² |
| Breaking out an old surface | £11–£45 per m² |
| Edging or kerb, bedded and haunched | £20–£55 per metre |
| Typical channel drain run | £380–£1,100 |
| Dropped kerb (vehicle crossover) construction | £1,100–£3,250 |
Guide figures for the South East, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
- Break-out of the old surface with waste removal and skip or grab lorry
- Levels set below the damp-proof course with falls away from the house
What the survey covers
- Steps, thresholds and door heights
- Ground conditions under the old surface and how deep the sub-base must be
- Whether front-garden planning rules apply
- Edges against lawns, beds, walls and neighbours
- The kerb: is it already dropped, and is it wide enough?
Do you need permission in Andover?
Andover is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Why choose Block Paving Contractors
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Replace an old drive in Andover: questions
Can you match the blocks to my house in Andover?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How much does a replacement block drive cost in Andover?
Our guide for Andover is £105–£195 per m² including VAT, so a 45 m² replacement drive is usually about £4,600–£8,750. Your fixed price follows the survey.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Replace an old drive near Andover
Nearby towns we cover for replace an old drive, and replace an old drive across Hampshire:
- Replace an old drive in Winchester
- Replace an old drive in Basingstoke
- Replace an old drive in Eastleigh
- Replace an old drive in Totton
- Replace an old drive in Southampton
- Replace an old drive in Hythe
