Planning a replacement block drive in Hayes
Hayes has everything from short terrace frontages to wide drives on newer estates, so the survey sets the layout and the dig.
Many London streets have controlled parking and narrow frontages, so we measure the car space and the crossover before anything else.
How much does a replacement block drive cost in Hayes?
Guide price in Hayes: £115–£215 per m² including VAT, which puts a 45 m² replacement drive at about £5,150–£9,700. These are London guide figures; the survey confirms the real price before you commit.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £115–£215 per m² |
| Breaking out an old surface | £12–£50 per m² |
| Edging or kerb, bedded and haunched | £25–£60 per metre |
| Typical channel drain run | £420–£1,200 |
| Dropped kerb (vehicle crossover) construction | £1,200–£3,600 |
Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
Before we price your replacement block drive
- Ground conditions under the old surface and how deep the sub-base must be
- Whether front-garden planning rules apply
- The kerb: is it already dropped, and is it wide enough?
- Trees and roots near the drive
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
Do you need permission in Hayes?
Hayes is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Replace an old drive in Hayes: questions
Do I need planning permission for a replacement block drive in Hayes?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Is the survey in Hayes free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
How much does a replacement block drive cost in Hayes?
Our guide for Hayes is £115–£215 per m² including VAT, so a 45 m² replacement drive is usually about £5,150–£9,700. Your fixed price follows the survey.
Replace an old drive near Hayes
Nearby towns we cover for replace an old drive, and replace an old drive across Greater London:
- Replace an old drive in Southall
- Replace an old drive in Heston
- Replace an old drive in Greenford
- Replace an old drive in Uxbridge
- Replace an old drive in Ruislip
- Replace an old drive in Hounslow
