Replacing tarmac or concrete with block paving in Bearsden: the local picture
Bearsden is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Bearsden?
Expect replacement block drives in Bearsden to come in at around £95–£180 per m², including VAT at 20%. As an example, a 45 m² replacement drive usually comes to between £4,300 and £8,100.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our replace an old drive service
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- New edging, sub-base where needed, and the block drive
- Assessment of the old base: keep, top up or replace
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
- Drainage added where the old drive sent water to the house or road
What we check on a Bearsden survey
- Whether front-garden planning rules apply
- Steps, thresholds and door heights
- Where rain will go: falls, lawn, border, channel or soakaway
- Ground conditions under the old surface and how deep the sub-base must be
- Block range, thickness, colour and pattern to suit the house
Do you need permission in Bearsden?
Bearsden is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
What you can expect from us
One point of contact
You deal with one team from survey to sign-off, with work carried out by paving teams working under S&K.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Replace an old drive in Bearsden: questions
Is the survey in Bearsden free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Do I need planning permission for a replacement block drive in Bearsden?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How much does a replacement block drive cost in Bearsden?
Our guide for Bearsden is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Replace an old drive near Bearsden
Nearby towns we cover for replace an old drive, and replace an old drive across Glasgow and Dunbartonshire:
- Replace an old drive in Milngavie
- Replace an old drive in Clydebank
- Replace an old drive in Bishopbriggs
- Replace an old drive in Kirkintilloch
- Replace an old drive in Rutherglen
- Replace an old drive in Dumbarton
