Planning a replacement block drive in St Andrews
St Andrews is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in St Andrews?
Expect replacement block drives in St Andrews to come in at around £95–£180 per m², including VAT at 20%. As an example, a 45 m² replacement drive usually comes to between £4,300 and £8,100.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Break-out of the old surface with waste removal and skip or grab lorry
- Assessment of the old base: keep, top up or replace
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Drainage added where the old drive sent water to the house or road
What we check on a St Andrews survey
- Ground conditions under the old surface and how deep the sub-base must be
- Access for a mini-digger, skip or grab lorry
- Where rain will go: falls, lawn, border, channel or soakaway
- The kerb: is it already dropped, and is it wide enough?
- Where an electric vehicle charger cable might run
Planning and kerb rules in St Andrews
St Andrews is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Replace an old drive in St Andrews: questions
Is the survey in St Andrews free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
Do you cover Cupar, Methil and Glenrothes?
Yes. We cover St Andrews and the places around it, including Cupar, Methil and Glenrothes, and the rest of Fife.
How much does a replacement block drive cost in St Andrews?
Our guide for St Andrews is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in St Andrews?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
Replace an old drive near St Andrews
Nearby towns we cover for replace an old drive, and replace an old drive across Fife:
- Replace an old drive in Cupar
- Replace an old drive in Methil
- Replace an old drive in Glenrothes
- Replace an old drive in Kirkcaldy
