County Antrim · Replace an old drive

Replacing tarmac or concrete with block paving in Lisburn

We quote replacement block drives throughout Lisburn and County Antrim. The survey sets the depth of dig and the drainage; the pattern and colour are your choice.

  • Postcodes BT27, BT28, BT17
  • £90–£170 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Replacing tarmac or concrete with block paving in Lisburn: the local picture

Lisburn has a big mix of housing, from older terraces near the centre to newer estates further out, so no two drives here start from the same ground.

Wet winters in Northern Ireland make falls, edge restraints and full joints especially important.

How much does a replacement block drive cost in Lisburn?

Guide price in Lisburn£90–£170 per m²Including VAT at 20%

For Lisburn, our guide is £90–£170 per m² including VAT, so a 45 m² replacement drive is likely to be £4,050–£7,700. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£90–£170 per m²
Breaking out an old surface£9.50–£40 per m²
Edging or kerb, bedded and haunched£19–£50 per metre
Typical channel drain run£330–£950
Dropped kerb (vehicle crossover) construction£950–£2,850

Guide figures for Northern Ireland, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our replace an old drive service

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Drainage added where the old drive sent water to the house or road
  • New edging, sub-base where needed, and the block drive
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Levels set below the damp-proof course with falls away from the house
  • Assessment of the old base: keep, top up or replace

What the survey covers

  • Existing manhole and inspection covers, and whether to recess them
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Where an electric vehicle charger cable might run
  • Trees and roots near the drive
  • Ground conditions under the old surface and how deep the sub-base must be

Do you need permission in Lisburn?

Lisburn is in Northern Ireland, so these rules apply:

In Northern Ireland, a hard surface between the front of the house and the road that covers or replaces more than 5 m² must be porous or permeable, or drain to a permeable area within the property, to be permitted development.

Hard surfaces within the grounds of a listed building need listed building consent. Planning is handled by your district council, so check with its planning office if you are unsure.

Dropped kerbs in Northern Ireland are approved by DfI Roads (the Department for Infrastructure), not the council; check planning separately with the council.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

How it works

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

How we work

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Replace an old drive in Lisburn: questions

How much does a replacement block drive cost in Lisburn?

Our guide for Lisburn is £90–£170 per m² including VAT, so a 45 m² replacement drive is usually about £4,050–£7,700. Your fixed price follows the survey.

Can you match the blocks to my house in Lisburn?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Belfast, Castlereagh and Newtownabbey?

Yes. We cover Lisburn and the places around it, including Belfast, Castlereagh and Newtownabbey, and the rest of County Antrim.

Replace an old drive near Lisburn

Nearby towns we cover for replace an old drive, and replace an old drive across County Antrim:

Other block paving services in Lisburn

Or see all block paving services in Lisburn.

Next step

Get a guide price in two minutes

Ready to talk about your replacement block drive? Send your postcode and a few details, and we will arrange the next step.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote