Ayrshire · Replace an old drive

Replacing tarmac or concrete with block paving in Largs

Replacing tarmac or concrete with block paving in Largs: built on a properly dug and compacted base, edged in concrete and laid to falls that take water away from the house.

  • Postcodes KA30, KA29, KA28
  • £95–£180 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Largs

Largs is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.

In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

How much does a replacement block drive cost in Largs?

Guide price in Largs£95–£180 per m²Including VAT at 20%

Expect replacement block drives in Largs to come in at around £95–£180 per m², including VAT at 20%. As an example, a 45 m² replacement drive usually comes to between £4,300 and £8,100.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£95–£180 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What does a replacement block drive involve?

Replacing an old drive with block paving means breaking out the existing tarmac, concrete or gravel, checking what is underneath, and then building a block drive on a sound base. Many older tarmac and concrete drives have cracked, sunk or broken up, which is why this is such a common way into block paving.

  • Drainage added where the old drive sent water to the house or road
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Assessment of the old base: keep, top up or replace
  • Levels set below the damp-proof course with falls away from the house
  • New edging, sub-base where needed, and the block drive

Before we price your replacement block drive

  • Steps, thresholds and door heights
  • Edges against lawns, beds, walls and neighbours
  • Block range, thickness, colour and pattern to suit the house
  • Where rain will go: falls, lawn, border, channel or soakaway
  • The kerb: is it already dropped, and is it wide enough?

Rules for front drives in Largs

Largs is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Quick details

    Your postcode and the job. It takes a minute.

  2. On-site check

    Measurements, levels against the damp-proof course, ground and drainage.

  3. Itemised quote

    Fixed once the specification is agreed, with no vague extras.

  4. Laid and finished

    Compacted, jointed and handed back clean.

Why choose Block Paving Contractors

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Replace an old drive in Largs: questions

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

Do I need planning permission for a replacement block drive in Largs?

In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.

Do you cover Ardrossan, Saltcoats and Kilwinning?

Yes. We cover Largs and the places around it, including Ardrossan, Saltcoats and Kilwinning, and the rest of Ayrshire.

Replace an old drive near Largs

Nearby towns we cover for replace an old drive, and replace an old drive across Ayrshire:

Other block paving services in Largs

Or see all block paving services in Largs.

Next step

Get a guide price in two minutes

Ready to talk about your replacement block drive? Send your postcode and a few details, and we will arrange the next step.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote