Planning a replacement block drive in Stevenston
Stevenston is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
In Scotland, front paving must be porous or drain within the property whatever its size, so drainage is part of every design.
In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.
How much does a replacement block drive cost in Stevenston?
Most replacement block drive quotes in Scotland fall within £95–£180 per m² including VAT. A 45 m² replacement drive would usually be about £4,300–£8,100, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £95–£180 per m² |
| Breaking out an old surface | £10–£40 per m² |
| Edging or kerb, bedded and haunched | £20–£50 per metre |
| Typical channel drain run | £350–£1,000 |
| Dropped kerb (vehicle crossover) construction | £1,000–£3,000 |
Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
- Assessment of the old base: keep, top up or replace
- Levels set below the damp-proof course with falls away from the house
- New edging, sub-base where needed, and the block drive
- Drainage added where the old drive sent water to the house or road
- Break-out of the old surface with waste removal and skip or grab lorry
What we check on a Stevenston survey
- Where rain will go: falls, lawn, border, channel or soakaway
- Where an electric vehicle charger cable might run
- Edges against lawns, beds, walls and neighbours
- Existing manhole and inspection covers, and whether to recess them
- Trees and roots near the drive
Do you need permission in Stevenston?
Stevenston is in Scotland, so these rules apply:
In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.
Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.
A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Water planned first
Falls, channels and soakaways are designed before the pattern is chosen.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Replace an old drive in Stevenston: questions
How long does a replacement block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Do I need planning permission for a replacement block drive in Stevenston?
In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.
How much does a replacement block drive cost in Stevenston?
Our guide for Stevenston is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
Replace an old drive near Stevenston
Nearby towns we cover for replace an old drive, and replace an old drive across Ayrshire:
- Replace an old drive in Saltcoats
- Replace an old drive in Kilwinning
- Replace an old drive in Ardrossan
- Replace an old drive in Irvine
- Replace an old drive in Troon
- Replace an old drive in Kilmarnock
