Highlands · Permeable paving

Permeable block paving in Inverness

If you are in Inverness (IV1, IV3, IV2, IV8) and want a permeable block drive, we will come out, measure up and give you a fixed written price once the specification is agreed.

  • Postcodes IV1, IV3, IV2
  • £105–£170 per m² inc VAT
  • By arrangement
Grey permeable block paving with grit-filled joints soaking up rain on a driveway

What to know before a permeable block drive in Inverness

Inverness is a sizeable town with a mix of semis, terraces and newer estates, and many drives here were first laid decades ago.

Frost and heavy rain test paving in Scotland, so a well-drained sub-base and full joints matter as much as the blocks.

In Scotland block paving is often called monoblock; it is the same thing, and the same rules for the base, edging and drainage apply.

Work in the Highlands is by arrangement: we confirm availability and any travel charge before a visit, and many jobs can be priced from photos first.

How much does a permeable block drive cost in Inverness?

Guide price in Inverness£105–£170 per m²Including VAT at 20%

Most permeable block drive quotes in Scotland fall within £105–£170 per m² including VAT. A 50 m² drive would usually be about £5,250–£8,500, with any extras listed separately on your quote.

ItemGuide price inc VAT
Permeable block paving driveway£105–£170 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for Scotland, checked 9 November 2026. See all prices or use the guide price tool.

What you get with our permeable paving service

Permeable block paving is block paving built so that rainwater drains down through the joints into a deep, open-graded stone sub-base, where it is stored and soaks away slowly into the ground or is piped off. The blocks have small spacers or wider joints filled with fine grit instead of sand.

  • Ground check: how well the soil drains and how high the water table sits
  • Deeper dig-out for the open-graded sub-base
  • Grit laying course and permeable blocks with grit-filled joints
  • Open-graded crushed stone (no fines) laid and compacted in layers
  • Edge restraints and any overflow or outlet the design needs

What we check on an Inverness survey

  • Steps, thresholds and door heights
  • Access for a mini-digger, skip or grab lorry
  • Where rain will go: falls, lawn, border, channel or soakaway
  • The kerb: is it already dropped, and is it wide enough?
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)

Planning and kerb rules in Inverness

Inverness is in Scotland, so these rules apply:

In Scotland, a hard surface between the house and the road is permitted development only if it is porous or drains to a permeable area within the property. There is no 5 m² threshold: the rule applies whatever the size.

Hard surfaces are not permitted development in a conservation area or within the grounds of a listed building, so planning permission is needed there.

A dropped kerb needs consent from your council as roads authority under section 56 of the Roads (Scotland) Act 1984, and planning permission may also be needed depending on the road.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

How we work

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Permeable paving in Inverness: questions

Do I need planning permission for a permeable block drive in Inverness?

In Scotland, front paving must be porous or drain within your boundary at any size, and permitted development does not apply in conservation areas. Ask us on the survey if you are unsure.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Do you cover Nairn and Alness?

Yes. We cover Inverness and the places around it, including Nairn and Alness, and the rest of the Highlands.

Can you match the blocks to my house in Inverness?

We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.

Permeable paving near Inverness

Nearby towns we cover for permeable paving, and permeable paving across Highlands:

Other block paving services in Inverness

Or see all block paving services in Inverness.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote