Greater London · Permeable paving

Permeable block paving in Eltham

Permeable block paving in Eltham: built on a properly dug and compacted base, edged in concrete and laid to falls that take water away from the house.

  • Postcodes SE9, SE12, BR7
  • £125–£205 per m² inc VAT
  • Free survey for new paving
Grey permeable block paving with grit-filled joints soaking up rain on a driveway

What to know before a permeable block drive in Eltham

In Eltham, many front gardens have already been paved once, so new paving often starts with breaking out the old surface.

Front gardens in much of London are short, so parking depth and the dropped kerb usually decide whether a drive is possible.

How much does a permeable block drive cost in Eltham?

Guide price in Eltham£125–£205 per m²Including VAT at 20%

Most permeable block drive quotes in London fall within £125–£205 per m² including VAT. A 50 m² drive would usually be about £6,300–£10,200, with any extras listed separately on your quote.

ItemGuide price inc VAT
Permeable block paving driveway£125–£205 per m²
Breaking out an old surface£12–£50 per m²
Edging or kerb, bedded and haunched£25–£60 per metre
Typical channel drain run£420–£1,200
Dropped kerb (vehicle crossover) construction£1,200–£3,600

Guide figures for London, checked 9 November 2026. See all prices or use the guide price tool.

What does a permeable block drive involve?

It is the straightforward way to pave a front garden without sending rain into the road, which matters because in England a non-permeable front surface over 5 m² that does not drain to a permeable area within the property needs planning permission, and in Wales any new front surface must be permeable or drain within the property. The build is different from a standard drive from the ground up, so it has to be designed as permeable rather than just using different blocks.

  • Open-graded crushed stone (no fines) laid and compacted in layers
  • Ground check: how well the soil drains and how high the water table sits
  • Edge restraints and any overflow or outlet the design needs
  • Deeper dig-out for the open-graded sub-base
  • Geotextile layer where the design needs one

What the survey covers

  • Access for a mini-digger, skip or grab lorry
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Trees and roots near the drive
  • The kerb: is it already dropped, and is it wide enough?
  • Ground conditions under the old surface and how deep the sub-base must be

Rules for front drives in Eltham

Eltham is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

From enquiry to finished paving

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

How we work

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Repair before replace

If your drive can be fixed or re-laid, we will say so.

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Permeable paving in Eltham: questions

How long does a permeable block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

How much does a permeable block drive cost in Eltham?

Our guide for Eltham is £125–£205 per m² including VAT, so a 50 m² drive is usually about £6,300–£10,200. Your fixed price follows the survey.

Do you cover Welling, Catford and Greenwich?

Yes. We cover Eltham and the places around it, including Welling, Catford and Greenwich, and the rest of Greater London.

Do I need planning permission for a permeable block drive in Eltham?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Permeable paving near Eltham

Nearby towns we cover for permeable paving, and permeable paving across Greater London:

Other block paving services in Eltham

Or see all block paving services in Eltham.

Next step

Get a guide price in two minutes

Ready to talk about your permeable block drive? Send your postcode and a few details, and we will arrange the next step.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote