Permeable block paving in Dromore: the local picture
Around Dromore, plots are often larger and drives longer, so edging, falls and the route the water takes need planning.
Dropped kerbs in Northern Ireland go through DfI Roads, so we build that timing into the plan for new drives.
How much does a permeable block drive cost in Dromore?
In Northern Ireland, a permeable block drive usually costs £100–£160 per m² including VAT. For a 50 m² drive, that is roughly £5,000–£8,100. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Permeable block paving driveway | £100–£160 per m² |
| Breaking out an old surface | £9.50–£40 per m² |
| Edging or kerb, bedded and haunched | £19–£50 per metre |
| Typical channel drain run | £330–£950 |
| Dropped kerb (vehicle crossover) construction | £950–£2,850 |
Guide figures for Northern Ireland, checked 9 November 2026. See all prices or use the guide price tool.
What does a permeable block drive involve?
It is the straightforward way to pave a front garden without sending rain into the road, which matters because in England a non-permeable front surface over 5 m² that does not drain to a permeable area within the property needs planning permission, and in Wales any new front surface must be permeable or drain within the property. The build is different from a standard drive from the ground up, so it has to be designed as permeable rather than just using different blocks.
- Edge restraints and any overflow or outlet the design needs
- Ground check: how well the soil drains and how high the water table sits
- Open-graded crushed stone (no fines) laid and compacted in layers
- Deeper dig-out for the open-graded sub-base
- Grit laying course and permeable blocks with grit-filled joints
Before we price your permeable block drive
- Steps, thresholds and door heights
- Edges against lawns, beds, walls and neighbours
- The kerb: is it already dropped, and is it wide enough?
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Ground conditions under the old surface and how deep the sub-base must be
Do you need permission in Dromore?
Dromore is in Northern Ireland, so these rules apply:
In Northern Ireland, a hard surface between the front of the house and the road that covers or replaces more than 5 m² must be porous or permeable, or drain to a permeable area within the property, to be permitted development.
Hard surfaces within the grounds of a listed building need listed building consent. Planning is handled by your district council, so check with its planning office if you are unsure.
Dropped kerbs in Northern Ireland are approved by DfI Roads (the Department for Infrastructure), not the council; check planning separately with the council.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
What happens next
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Itemised quotes
Break-out, waste, edging, drainage and covers are separate lines you can see.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Permeable paving in Dromore: questions
How much does a permeable block drive cost in Dromore?
Our guide for Dromore is £100–£160 per m² including VAT, so a 50 m² drive is usually about £5,000–£8,100. Your fixed price follows the survey.
Is the survey in Dromore free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How long does a permeable block drive take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
Permeable paving near Dromore
Nearby towns we cover for permeable paving, and permeable paving across County Tyrone:
