Planning a block paved driveway in Welshpool
In and around Welshpool, village-style frontages sit alongside newer cul-de-sacs, so the right block often depends on the age of the house.
Hilly streets in much of Wales mean many drives slope, which shapes the falls, the edging and the water route.
How much does a block paved driveway cost in Welshpool?
Most block paved driveway quotes in Wales fall within £80–£130 per m² including VAT. A 50 m² double drive would usually be about £3,950–£6,500, with any extras listed separately on your quote.
| Item | Guide price inc VAT |
|---|---|
| Concrete block driveway, new sub-base | £80–£130 per m² |
| Breaking out an old surface | £9.50–£35 per m² |
| Edging or kerb, bedded and haunched | £19–£45 per metre |
| Typical channel drain run | £330–£930 |
| Dropped kerb (vehicle crossover) construction | £930–£2,800 |
Guide figures for Wales, checked 9 November 2026. See all prices or use the guide price tool.
What you get with our block paved driveways service
A block paved driveway is a surface of small concrete or clay blocks laid tightly on a bed of sharp sand, held in by a fixed edge and locked together with kiln-dried jointing sand. Laid on a properly dug and compacted sub-base, it carries cars for decades, and a single damaged block can be lifted and replaced without breaking the surface.
- Kiln-dried sand brushed in and the surface vibrated with a plate compactor
- Cuts at edges, around covers and against the house
- Edge restraints or kerbs bedded and haunched in concrete
- Crushed-stone sub-base laid in layers and compacted
- Survey, measurements and a written, itemised quote
What we check on a Welshpool survey
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- The kerb: is it already dropped, and is it wide enough?
- Steps, thresholds and door heights
- Where rain will go: falls, lawn, border, channel or soakaway
- Where an electric vehicle charger cable might run
Rules for front drives in Welshpool
Welshpool is in Wales, so these rules apply:
In Wales, any new or replacement hard surface at the front of a house should be permeable or drain to a permeable area within the property to avoid needing planning permission. Unlike England, there is no 5 m² allowance for new paving; only repairs of up to 5 m² of existing surface are exempt.
Since January 2019, construction work covering 100 m² or more with drainage implications, including drives and patios, needs approval from the local SuDS Approving Body (SAB) before work starts, even where planning permission is not needed.
A dropped kerb needs your council's approval as highway authority, and a new access onto a classified road needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
How we work
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
The dig and sub-base in writing
Your quote states the depth of dig, the sub-base thickness and how it is compacted.
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Block paved driveways in Welshpool: questions
Can you match the blocks to my house in Welshpool?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
How long does a block paved driveway take to build?
Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
How much does a block paved driveway cost in Welshpool?
Our guide for Welshpool is £80–£130 per m² including VAT, so a 50 m² double drive is usually about £3,950–£6,500. Your fixed price follows the survey.
Block paved driveways near Welshpool
Nearby towns we cover for block paved driveways, and block paved driveways across Powys:
- Block paved driveways in Newtown
- Block paved driveways in Rhosllannerchrugog
- Block paved driveways in Wrexham
