Planning a block paved driveway in Brough
Brough is a smaller town, and many of its homes have more frontage to work with than city houses, which leaves room for borders and planting.
Yorkshire has everything from stone-built terraces to large new estates, so block choice often follows the house: clay or tumbled blocks for older homes, crisp concrete for newer ones.
How much does a block paved driveway cost in Brough?
In Yorkshire and the Humber, a block paved driveway usually costs £75–£125 per m² including VAT. For a 50 m² double drive, that is roughly £3,850–£6,300. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Concrete block driveway, new sub-base | £75–£125 per m² |
| Breaking out an old surface | £9–£35 per m² |
| Edging or kerb, bedded and haunched | £18–£45 per metre |
| Typical channel drain run | £320–£900 |
| Dropped kerb (vehicle crossover) construction | £900–£2,700 |
Guide figures for Yorkshire and the Humber, checked 9 November 2026. See all prices or use the guide price tool.
What is included?
We build block drives for homeowners from scratch: digging out the old surface, setting edge restraints in concrete, building and compacting the sub-base, screeding the laying course, laying the pattern, cutting in the edges and vibrating the blocks into the sand. Every quote states the depth of dig, the sub-base thickness, the edging, the falls and where the water goes.
- Cuts at edges, around covers and against the house
- Edge restraints or kerbs bedded and haunched in concrete
- Removal of the old surface and soil to the agreed depth, with waste taken away
- Crushed-stone sub-base laid in layers and compacted
- Kiln-dried sand brushed in and the surface vibrated with a plate compactor
What we check on a Brough survey
- Edges against lawns, beds, walls and neighbours
- Ground conditions under the old surface and how deep the sub-base must be
- Where an electric vehicle charger cable might run
- The kerb: is it already dropped, and is it wide enough?
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
Do you need permission in Brough?
Brough is in England, so these rules apply:
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
From enquiry to finished paving
Tell us about the job
Use the form, the quote tool, WhatsApp or a call.
We take a look
A survey visit, or photos for smaller repair and cleaning jobs.
Price in writing
Every line itemised, including the dig, edging and drainage.
Booked and built
Agreed start date, then the work, the final clean-down and the joint top-up.
How we work
Repair before replace
If your drive can be fixed or re-laid, we will say so.
Edges set in concrete
Every edge restraint is bedded and haunched, so the paving cannot creep.
Clean finish
The site is swept, the joints are filled and you are shown how to look after the paving.
Honest timescales
We tell you how long the job takes and what can delay it, such as approvals and weather.
Block paved driveways in Brough: questions
What happens to my old drive?
It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.
Is the survey in Brough free?
Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.
How much does a block paved driveway cost in Brough?
Our guide for Brough is £75–£125 per m² including VAT, so a 50 m² double drive is usually about £3,850–£6,300. Your fixed price follows the survey.
Do you cover Hull, Beverley and Goole?
Yes. We cover Brough and the places around it, including Hull, Beverley and Goole, and the rest of the East Riding of Yorkshire.
Block paved driveways near Brough
Nearby towns we cover for block paved driveways, and block paved driveways across East Riding of Yorkshire:
- Block paved driveways in Hull
- Block paved driveways in Beverley
- Block paved driveways in Goole
- Block paved driveways in Driffield
