West Midlands · Replace an old drive

Replacing tarmac or concrete with block paving in Birmingham

Our replacing tarmac or concrete with block paving service covers Birmingham and nearby Aston, from first measurements to the final sweep of kiln-dried sand. You get a written, itemised quote before anything is booked.

  • Postcodes B3, B2, B4
  • £95–£180 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

Planning a replacement block drive in Birmingham

Across Birmingham, front gardens range from narrow terrace plots to broad modern drives, and the best block, pattern and drainage choice changes with them.

Clay ground is widespread in the West Midlands, so the sub-base depth and drainage are checked on every survey.

How much does a replacement block drive cost in Birmingham?

Guide price in Birmingham£95–£180 per m²Including VAT at 20%

For Birmingham, our guide is £95–£180 per m² including VAT, so a 45 m² replacement drive is likely to be £4,300–£8,100. Smaller jobs cost more per square metre because set-up and waste costs do not shrink with the area.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£95–£180 per m²
Breaking out an old surface£10–£40 per m²
Edging or kerb, bedded and haunched£20–£50 per metre
Typical channel drain run£350–£1,000
Dropped kerb (vehicle crossover) construction£1,000–£3,000

Guide figures for the West Midlands, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Break-out of the old surface with waste removal and skip or grab lorry
  • Levels set below the damp-proof course with falls away from the house
  • Drainage added where the old drive sent water to the house or road
  • New edging, sub-base where needed, and the block drive
  • Assessment of the old base: keep, top up or replace

What the survey covers

  • Where rain will go: falls, lawn, border, channel or soakaway
  • The kerb: is it already dropped, and is it wide enough?
  • Steps, thresholds and door heights
  • Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
  • Block range, thickness, colour and pattern to suit the house

Do you need permission in Birmingham?

Birmingham is in England, so these rules apply:

In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.

Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.

A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

How we work

The dig and sub-base in writing

Your quote states the depth of dig, the sub-base thickness and how it is compacted.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Water planned first

Falls, channels and soakaways are designed before the pattern is chosen.

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Replace an old drive in Birmingham: questions

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

How much does a replacement block drive cost in Birmingham?

Our guide for Birmingham is £95–£180 per m² including VAT, so a 45 m² replacement drive is usually about £4,300–£8,100. Your fixed price follows the survey.

Do I need planning permission for a replacement block drive in Birmingham?

In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.

Is the survey in Birmingham free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Replace an old drive near Birmingham

Nearby towns we cover for replace an old drive, and replace an old drive across West Midlands:

Other block paving services in Birmingham

Or see all block paving services in Birmingham.

Next step

Get a guide price in two minutes

Tell us what you have in mind for Birmingham, and we will put a written price together.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote