South Glamorgan · Replace an old drive

Replacing tarmac or concrete with block paving in Barry

Planning a replacement block drive in Barry? Start with a free survey: we check levels against the damp-proof course, the ground, the drainage and the kerb before pricing anything.

  • Postcodes CF62, CF63
  • £90–£165 per m² inc VAT
  • Free survey for new paving
Driveway half old cracked tarmac and half new brindle herringbone block paving

What to know before a replacement block drive in Barry

In Barry, many front gardens have already been paved once, so new paving often starts with breaking out the old surface.

Wales is wetter than most of England, and new front paving has to be permeable or drain within the property, so drainage is designed in from the start.

How much does a replacement block drive cost in Barry?

Guide price in Barry£90–£165 per m²Including VAT at 20%

In Wales, a replacement block drive usually costs £90–£165 per m² including VAT. For a 45 m² replacement drive, that is roughly £4,000–£7,550. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.

ItemGuide price inc VAT
Replace tarmac or concrete with block (incl. break-out)£90–£165 per m²
Breaking out an old surface£9.50–£35 per m²
Edging or kerb, bedded and haunched£19–£45 per metre
Typical channel drain run£330–£930
Dropped kerb (vehicle crossover) construction£930–£2,800

Guide figures for Wales, checked 9 November 2026. See all prices or use the guide price tool.

What is included?

Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.

  • Drainage added where the old drive sent water to the house or road
  • New edging, sub-base where needed, and the block drive
  • Break-out of the old surface with waste removal and skip or grab lorry
  • Assessment of the old base: keep, top up or replace
  • Levels set below the damp-proof course with falls away from the house

Before we price your replacement block drive

  • Steps, thresholds and door heights
  • Where an electric vehicle charger cable might run
  • The kerb: is it already dropped, and is it wide enough?
  • Ground conditions under the old surface and how deep the sub-base must be
  • Block range, thickness, colour and pattern to suit the house

Rules for front drives in Barry

Barry is in Wales, so these rules apply:

In Wales, any new or replacement hard surface at the front of a house should be permeable or drain to a permeable area within the property to avoid needing planning permission. Unlike England, there is no 5 m² allowance for new paving; only repairs of up to 5 m² of existing surface are exempt.

Since January 2019, construction work covering 100 m² or more with drainage implications, including drives and patios, needs approval from the local SuDS Approving Body (SAB) before work starts, even where planning permission is not needed.

A dropped kerb needs your council's approval as highway authority, and a new access onto a classified road needs planning permission.

General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.

What happens next

  1. Tell us about the job

    Use the form, the quote tool, WhatsApp or a call.

  2. We take a look

    A survey visit, or photos for smaller repair and cleaning jobs.

  3. Price in writing

    Every line itemised, including the dig, edging and drainage.

  4. Booked and built

    Agreed start date, then the work, the final clean-down and the joint top-up.

How we work

Itemised quotes

Break-out, waste, edging, drainage and covers are separate lines you can see.

Honest timescales

We tell you how long the job takes and what can delay it, such as approvals and weather.

Clean finish

The site is swept, the joints are filled and you are shown how to look after the paving.

Edges set in concrete

Every edge restraint is bedded and haunched, so the paving cannot creep.

Replace an old drive in Barry: questions

How long does a replacement block drive take to build?

Most homes take between three and seven working days, depending on size, the dig and the drainage. Your quote gives the expected duration.

What happens to my old drive?

It is broken out and taken away by skip or grab lorry, listed as its own line on your quote.

Is the survey in Barry free?

Yes, for new paving here: the survey and written quote are free with no obligation. Repairs and cleaning are usually priced from photos, or from a short visit where needed.

Do I need planning permission for a replacement block drive in Barry?

In Wales, new front paving should be permeable or drain within your boundary to avoid planning permission, and drives of 100 m² or more need SuDS approval. Ask us on the survey if you are unsure.

Replace an old drive near Barry

Nearby towns we cover for replace an old drive, and replace an old drive across South Glamorgan:

Other block paving services in Barry

Or see all block paving services in Barry.

Next step

Get a guide price in two minutes

Want a number before a visit? Try the guide price tool, then book a survey to fix it.

Hands laying charcoal paving blocks in herringbone on a sand bed
CallGet a quote