How much does a replacement block drive cost in North Yorkshire?
In Yorkshire and the Humber, a replacement block drive usually costs £85–£160 per m² including VAT. For a 45 m² replacement drive, that is roughly £3,850–£7,300. Your exact price depends on what the survey or your photos show, and is fixed in writing before anything is booked.
| Item | Guide price inc VAT |
|---|---|
| Replace tarmac or concrete with block (incl. break-out) | £85–£160 per m² |
| Breaking out an old surface | £9–£35 per m² |
| Edging or kerb, bedded and haunched | £18–£45 per metre |
| Typical channel drain run | £320–£900 |
| Dropped kerb (vehicle crossover) construction | £900–£2,700 |
Guide figures for Yorkshire and the Humber, checked 9 November 2026.
Towns we cover in North Yorkshire
Choose a town for local prices and details for replace an old drive:
What is included?
Sometimes the old base can be kept: a thick, sound concrete or well-compacted hardcore layer may only need trimming and topping up. Often it cannot, because it was too thin, has sunk or sits too high against the house. The survey checks levels against the damp-proof course and the existing base before the quote is written, so the price reflects the real dig.
Yorkshire has everything from stone-built terraces to large new estates, so block choice often follows the house: clay or tumbled blocks for older homes, crisp concrete for newer ones.
- Assessment of the old base: keep, top up or replace
- Drainage added where the old drive sent water to the house or road
- New edging, sub-base where needed, and the block drive
- Levels set below the damp-proof course with falls away from the house
- Break-out of the old surface with waste removal and skip or grab lorry
What the survey covers
- Ground conditions under the old surface and how deep the sub-base must be
- Levels against the damp-proof course (the finished paving must sit at least 150 mm below it)
- Where an electric vehicle charger cable might run
- Edges against lawns, beds, walls and neighbours
- Trees and roots near the drive
Rules for front drives in North Yorkshire
In England, paving in front of the house that covers more than 5 m² needs planning permission unless it is permeable or drains to a lawn, border or soakaway inside your boundary. Permeable block paving, or standard blocks laid to fall onto a planted strip, avoid the need for permission in most cases.
Flats and maisonettes, listed buildings, and homes covered by an Article 4 direction can have tighter rules, and conservation areas, National Parks and National Landscapes restrict some permitted development.
A dropped kerb needs your local highway authority's approval (usually the county, unitary, metropolitan or London borough council), and a new access onto an A, B or C classified road also needs planning permission.
General guidance, not legal advice. Your survey confirms what applies to your home. See the planning guide.
How it works
Quick details
Your postcode and the job. It takes a minute.
On-site check
Measurements, levels against the damp-proof course, ground and drainage.
Itemised quote
Fixed once the specification is agreed, with no vague extras.
Laid and finished
Compacted, jointed and handed back clean.
Replace an old drive in North Yorkshire: questions
How much does a replacement block drive cost in North Yorkshire?
Our guide for North Yorkshire is £85–£160 per m² including VAT, so a 45 m² replacement drive is usually about £3,850–£7,300. Your fixed price follows the survey.
Do I need planning permission for a replacement block drive in North Yorkshire?
In England, a front drive over 5 m² needs planning permission unless it is permeable or drains to a lawn or border within your boundary. Ask us on the survey if you are unsure.
Do you cover York, Middlesbrough and Harrogate?
Yes. We cover all of North Yorkshire, including York, Middlesbrough and Harrogate.
Can you match the blocks to my house in North Yorkshire?
We bring samples to the survey and suggest blocks and borders that suit the age and brick of the house. Final colour is your choice.
